Manfredi Polymerizer Acrydig 12
|
Acrydig 12 |
|
|
Power (W) |
1400 |
|
Chamber width (cm) |
26 |
|
Chamber depth (cm) |
31 |
|
Chamber useful height (cm) |
26 |
|
Capacity |
10-18 flasks |
|
External width (cm) |
30 |
|
External depth (cm) |
42 |
|
External height (cm) |
38 |
|
Net/Gross weight (kg) |
10/11 |
Polymerizer Acydig 12
Advantages:
✓ Entirely manufactured in stainless steel
✓ Intuitive programming
✓ Water level sensor
✓ Easy water drain
ACRYDIG polymerizing units are completely built in stainless steel to guarantee a longlasting life. The special design of the closing lid avoids any dispersion of steam or condensate dripping, thus ensuring the polymerization cycle in a steam saturated atmosphere. The wide opening and the adequate dimensions of the polymerization tank allow a rational accomodation of the flasks. The electronic board controls one-step or two-step polymerization cycles, a pre-start setting, the automatic switch off at the end of the cycle and constantly shows the cycle progress.
These parameters allow a controlled polymerization process with natural cooling, thus avoiding any micro-fracture of the resin, usually caused by a sudden cooling. Acrydig is also equipped with water tap on the side, to quickly drain the polymerization chamber. The heating cycle safety is ensured by a sensor, constantly checking the presence of water inside the chamber; in case the level is too low, the system automatically interrupts the heating.
ACRYDIG is available in depending on the capacity 12 clamped flasks.
